SYNOPSIS6tunnel [ -146dhfv ] [ -u username ] [ -i password ] [ -I password ] [ -l local_host ] [ -L limit ] [ -p pid_file ] [ -m map_file ] local_port remote_host [ remote_port ]
DESCRIPTION6tunnel allows you to use services provided by IPv6 hosts with IPv4-only applications and vice-versa. It can bind to any of your IPv4 (default) or IPv6 addresses and forward all data to IPv4 or IPv6 (default) host. For example
- 6tunnel -1 6668 irc6.net 6667
will be enough to connect to IPv6 irc server with
- irc foobar localhost:6668
If you don't wish to run 6tunnel every time you want to show your :c001: or :dead: IPv6 address on IRC, you can use -i parameter, which makes 6tunnel ask your client for specified password. Just run
- 6tunnel -i dupa.8 31337 irc6.net 6667
and then type
- irc foobar localhost:31337:dupa.8
If your IRC server requires you to send password, specify it with -I parameter -- after successful proxy authentication 6tunnel will send it to the server.
6tunnel can also be used as a tunnel for all other combinations of IPv4 and IPv6 endpoints. If remote host doesn't have any IPv6 addresses, 6tunnel will use the IPv4 one. In other cases, use -4 parameter which makes IPv4 address the preferred one. For IPv6-to-any tunnels use -6 which makes 6tunnel bind to IPv6 address.
- Exit after first connection.
- Prefer IPv4 endpoint if the machine has both address types.
- Listen on IPv6 address (IPv4 is default).
- Don't detach.
- Force tunneling even if remote host is not resolvable at the execution time.
- Print hex dump of every packet received or sent (hu-huh, Beavis, he said hex dump!)
- -u username
- Change UID and GID after bind().
- -i password
- Act as an IRC proxy and require user to authenticate.
- -I password
- If you are using 6tunnel as an IRC proxy and the IRC server requires you to send password, place it right here.
- -l local_host
- Listen on specified address (IPv4, or IPv6 if -6 used).
- -L limit
- Limit simultaneous connections.
- -p pid_file
- Write down pid to specified file.
- -s source_host
- Connect to the remote host using specified source address.
- -m map_file
- Binds to specified IPv6 addresses on basis of source IPv4 address. The file contains one mapping per line with IPv4 source address and corresponding IPv6 address. Only listed hosts are allowed to connect. If you want to allow any host, add mapping for default or 0.0.0.0 address. Example:
192.168.0.2 3ffe:8010:18::1000:2 192.168.0.3 3ffe:8010:18::1000:3
- Be verbose and don't detach.