pcnet-diag(8) EEPROM setup and diagnostic program for ethernet cards based on the AMD PCnet/PCI series chips.


pci-config [options]


pci-config is a program that you can use to diagnose problems with ethernet cards


These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-# <device-index>
Operate only on device <device-index>.
-a, --show_addresses
Show PCI registers
-S, --sleep
Put device to sleep (ACPI D3).
-W, --wake
Wake a sleeping device (ACPI D0 state).
-B, --bus <bus>
Show only devices on BUS.
-A, --set-addresses <addr>
Set PCI address register 1 to the <addr>.
-D, --debug
Show details of operations.
-f, --force
Override checks and perform the operation.
-u, --usage
Show a long usage message.


pci-config was written and is still maintained by Donald Becker <[email protected]>. This manual page was written by Alain Schroeder <[email protected]>, for the Debian GNU/Linux system (but may be used by others).