SYNOPSISTo compile this driver into the kernel, place the following lines in your kernel configuration file:
device sound device snd_gusc
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:
Non-PnP cards require the following lines in device.hints5:
hint.gusc.0.at="isa" hint.gusc.0.port="0x220" hint.gusc.0.irq="5" hint.gusc.0.drq="1" hint.gusc.0.flags="0x13"
DESCRIPTIONThe bridge driver allows the generic audio driver sound(4) to attach to Gravis UltraSound sound cards.
The value of flags specifies the secondary DMA channel. If the secondary DMA channel is C, set the flags to (C | 0x10). For a sound card without the secondary DMA channel, the flags should be set to zero.
HARDWAREThe driver supports the following sound cards:
- Gravis UltraSound MAX
- Gravis UltraSound PnP
- xxx: gus pcm not attached, out of memory
- There are not enough memory to drive the device.
HISTORYThe device driver first appeared in Fx 4.0 .
BUGSRecording pcm sound data is not supported yet.