SYNTAX
arrayprobe [-f device] [-r] [-o] [-i]
DESCRIPTION
This program is capable of checking the status HP (Compaq) array controllers (devices using the Linux cciss and ida drivers). By default it runs in a non verbose mode that can be used as a nagios check or periodic cron job.
OPTIONS
- -f <device>
- Device to open.
- -r
- Report (verbose) mode.
- -o
- Only read new events (since last run, CCISS devices only).
- -i <host>
-
Force ida ioctls. (use with -f if the device is supported by the ida driver)
STATUS
The output is a single line of information about the worst state found. (If one logical drive is recovering and a second drive is in interim recovery mode. It will only report the failing drive.) The exitcodes can be used to determine the severity. The following exit values are returned:
- 0
- Normal.
- 1
- Warning.
- 2
-
Critical.
BUGS
- None known.