SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device xhci device ehci device uhci device ohci device usb device miibus device axge

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

if_axge_load="YES"

DESCRIPTION

The driver provides support for USB Gigabit Ethernet adapters based on the ASIX Electronics AX88179 USB 3.0 and AX88178A USB 2.0 chipsets.

The AX88179 and AX88178A contain a 10/100/1000 Ethernet MAC with a GMII interface for interfacing with the Gigabit Ethernet PHY.

These devices will operate with both USB 1.x and USB 2.0 controllers, and the AX88179 will operate with USB 3.0 controllers. Packets are received and transmitted over separate USB bulk transfer endpoints.

The driver supports the following media types:

autoselect

Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to rc.conf5.

10baseT/UTP

Set 10Mbps operation. The ifconfig(8) mediaopt option can also be used to select either full-duplex or half-duplex modes.

100baseTX

Set 100Mbps (Fast Ethernet) operation. The ifconfig(8) mediaopt option can also be used to select either full-duplex or half-duplex modes.

1000baseT

Set 1000Mbps (Gigabit Ethernet) operation (AX88178 only). The ifconfig(8) mediaopt option can also be used to select either full-duplex or half-duplex modes.

The driver supports the following media options:

full-duplex

Force full duplex operation.

half-duplex

Force half duplex operation.

For more information on configuring this device, see ifconfig(8).

HISTORY

The device driver first appeared in Fx 10.1 .

AUTHORS

The driver was written by An Kevin Lo Aq [email protected] and An Li-Wen Hsu Aq [email protected] . This manual page was adapted by An Mark Johnston Aq [email protected] from the axe(4) manual page.