SYNOPSIS

In sys/param.h In sys/bus.h Ft int Fo BUS_CONFIG_INTR Fa device_t dev int irq enum intr_trigger trig enum intr_polarity pol Fc

DESCRIPTION

The Fn BUS_CONFIG_INTR method allows bus or device drivers to provide interrupt polarity and trigger mode to parent busses. This typically bubbles all the way up to the root bus (e.g. nexus) where the necessary actions are taken to actually program the hardware. Since the Fn BUS_CONFIG_INTR method takes an interrupt number, it is assumed but not necessarily required that it is called prior to BUS_SETUP_INTR9.

The Fa trig argument can be one of:

INTR_TRIGGER_CONFORM

The interrupt trigger mode is standard for the bus to which the device is attached.

INTR_TRIGGER_EDGE

The interrupt is edge triggered. This means that the interrupt is raised by the rising edge of the signal on the interrupt line. The signal typically reverts to the original state so as to cause a spike.

INTR_TRIGGER_LEVEL

The interrupt is level triggered. This means that the interrupt is raised when the signal on the interrupt line transitions and remains unchanged after that until the interrupt has been serviced, after which the signal transitions back.

The Fa pol argument can be any one of:

INTR_POLARITY_CONFORM

The interrupt polarity is standard for the bus to which the device is attached.

INTR_POLARITY_HIGH

The interrupt is activated by a high voltage on the interrupt line.

INTR_POLARITY_LOW

The interrupt is activated by a low voltage on the interrupt line.

RETURN VALUES

Zero is returned on success, otherwise an appropriate error is returned.

HISTORY

The Fn BUS_CONFIG_INTR method first appeared in Fx 5.2 .

AUTHORS

This manual page was written by An Marcel Moolenaar Aq [email protected] .