DESCRIPTION

Configuration classes used by Config::Model

generated from LCDd.conf

Elements

Brightness

Set the initial brightness Optional. Type integer. upstream_default: '1000'.

Contrast

Set the initial contrast Optional. Type integer. upstream_default: '560'.

Device

Select the output device to use Optional. Type uniline. upstream_default: '/dev/lcd'.

Model

Select the LCD model Optional. Type enum. choice: '533', '631', '633', '635'. upstream_default: '633'.

OffBrightness

Set the initial off-brightness This value is used when the display is normally switched off in case LCDd is inactive. Optional. Type integer. upstream_default: '0'.

OldFirmware

Very old 633 firmware versions do not support partial screen updates using 'Send Data to LCD' command (31). For those devices it may be necessary to enable this flag. Optional. Type boolean. upstream_default: 'no'.

Reboot

Reinitialize the LCD's BIOS on driver start. Optional. Type boolean. upstream_default: 'no'.

Size

Override the LCD size known for the selected model. Usually setting this value should not be necessary. Optional. Type uniline. upstream_default: '20x4'.

Speed

Override the default communication speed known for the selected model. Default value depends on model Optional. Type enum. choice: '19200', '115200'.

USB

Enable the USB flag if the device is connected to an USB port. For serial ports leave it disabled. Optional. Type boolean. upstream_default: 'no'.