SYNOPSIS
create_bmp_for_symmetrical_stripline [-v] W H w bitmapfileWARNING
This man page is not a complete set of documentation - the complexity of the atlc project makes man pages not an ideal way to document it, although out of completeness, man pages are produced. The best documentation that was current at the time the version was produced should be found on your hard drive, usually at/usr/local/share/atlc/docs/html-docs/index.html
although it might be elsewhere if your system administrator chose to install the package elsewhere. Sometimes, errors are corrected in the documentation and placed at http://atlc.sourceforge.net/ before a new release of atlc is released. Please, if you notice a problem with the documentation - even spelling errors and typos, please let me know.
DESCRIPTION
create_bmp_for_symmetrical_stripline is a pre-processor for atlc, the finite difference program that is used to calculate the properties of a two-conductor electrical transmission line of arbitrary cross section. The program create_bmp_for_symmetrical_stripline is used as a fast way of generating bitmaps (there is no need to use a graphics program), for a 1 pixel thick conductor of width w, centrally located inside a pair of groundplanes of width W and separation H. This has an exact analytical answer, when the inner is infinitely thin and the width W is infinitely wide. This theoretical impedance is also calculated by the create_bmp_for_symmetrical_stripline. It is therefore used as a test of atlc.
----------------------------------------------------- ^
| | |
| | |
| <----------w-----------> | |
| | H
| | |
| | |
----------------------------------------------------- v
<-------------------------W------------------------->
The parameters 'W' and 'H' and the inner dimensions of the outer conductor. The outer dimensions of the inner conductor are 'w' and 'c'. The inner conductor is assumed to rest on a dielectric (Er2) which is 'd' wide and outer conductor an the inner conductor is offset 'b' from the left hand sidewall of the outer conductor. The whole region is surrounded by a dielectric of relative permittivity 'Er1'. The dielectrics 'Er1' and then 'Er1' and 'Er2' will both be 1.0
The bitmaps produced by create_bmp_for_symmetrical_stripline are 24-bit bit colour bitmaps, as are required by atlc. Currently create_bmp_for_symmetrical_stripline only produces bitmaps with
white (vacuum) dielectrics.
OPTIONS
-vPrint the theoeretical impedance Zo. This only works if the width W is sufficiently wide, otherwise atlc and the value printed here would disagree wildly.