fmscan(1) scan FM band for radio stations


fm [ -h ] [ -d device ] [ -t tuner ] [ -s freq ] [ -e freq ] [ -i freq ] [ -q ]


fmscan is a program to scan a frequency band for radio stations, using the video4linux interface introduced in 2.1.x series Linux kernels. It shows which ones have a accumulated signal strength of 50% or higher.


Print a usage message to standard output, and exit.
-d device
Sets device
as the device to tune. The default is /dev/radio0.
-t tuner
Sets tuner
as the tuner on the selected device to adjust. The default is tuner 0. Most radio devices have only a single tuner.
-s freq
Starting frequency for scan, in MHz. Default: 87.9.
-e freq
Ending frequency for scan, in MHz. Default: 107.9.
-i freq
Increment between scanned channels, in MHz. Default: 0.2.
-t percent
Signal strength threshold to consider a channel. Default: 50%.
Quiet mode. Suppresses progress output.


This process can take a while, and results vary greatly depending on the radio card in use. If your card's hardware cannot report signal strength, it will not produce useful results.

This program may not do much if your radio card's driver doesn't support fine tuning in 1/16000 MHz offsets. By default, V4L2 assumes 1/16 MHz tuning units, which introduces evil rounding errors on many frequencies.

Supports only tuner 0 on any given device.


Russell Kroll <[email protected]>, now maintained by Ben Pfaff <[email protected].>. This manpage written by Ben Pfaff.