SYNOPSIS
i3-wsbar -c <dzen2-commandline> [options]OPTIONS
- --command <command>
-
This command (at the moment only dzen2 is supported) will be started for each
output. %x will be replaced with the X coordinate of the output.
Example:
--command ``dzen2 -dock -x %x'' - --input-on <list-of-RandR-outputs>
-
Specifies on which outputs the contents of stdin should be appended to the
workspace bar.
Example:
--input-on ``LVDS1'' - --output-on <list-of-RandR-outputs>
- Specifies for which outputs i3-wsbar should start "command".
- --show-all
-
If enabled, all workspaces are shown (not only those of the current output).
Handy to use with "--output-on".