SYNTAX
vcd2fst [option]... [VCDFILE] [FSTFILE]
DESCRIPTION
Converts VCD files to FST files.
OPTIONS
- -v,--vcdname <filename>
- Specify VCD/FSDB/VPD/WLF input filename. Processing of filetypes other than VCD requires that the appropriate 2vcd converter was found during ./configure.
- -f,--fstname <filename>
- Specify FST output filename.
- -4,--fourpack
- Indicates that LZ4 should be used for value change data (default).
- -F,--fastpack
- Indicates that fastlz should be used instead of LZ4 for value change data.
- -4,--zlibpack
- Indicates that zlib should be used instead of LZ4 for value change data.
- -c,--compress
- Indicates that the entire file should be run through gzip on close. This results in much smaller files at the expense of a one-time decompression penalty on file open during reads.
- -p,--parallel
- Indicates that parallel mode should be enabled. This spawns a worker thread to continue with FST block processing while conversion continues on the main thread for new FST block data.
- -h,--help
- Show help screen.
EXAMPLES
Note that you should specify dumpfile.vcd directly or use "-" for stdin.
- vcd2fst dumpfile.vcd dumpfile.fst --compress
- This indicates that the FST file should be post-compressed on close.
AUTHORS
Anthony Bybell <[email protected]>