bluemon(1) DBUS interface to bluemon(1)

DESCRIPTION

This manual page documents briefly the DBUS interface to bluemon(1)

INTERFACE

Bluemon exposes 2 signals and 1 method. The bluemon process is registered on the system bus as cx.ath.matthew.bluemon.server. The exposed object is /cx/ath/matthew/bluemon/Bluemon and the exposed interface is cx.ath.matthew.bluemon.Bluemon. The signal interface is cx.ath.matthew.bluemon.ProximitySignal and have the names Connect and Disconnect which both have 1 parameter, which is the string representation of the bluetooth device ID which has been connected or disconnected. The method has the signature Status(IN STRING address, OUT STRING address, OUT BOOLEAN status, OUT UINT32 level). The in parameter may be blank in which case the first connected device will be returned. If status is true (device is connected) then the address and level will correspond to the device address and the reported link quality. Otherwise they will set to the address asked for and -1 respectively.
 

This information is also available as an XML protocol description in /usr/share/doc/bluemon/bluemon-dbus.xml
 

AUTHOR

This manual page was written by Matthew Johnson <[email protected]> for the Debian system (but may be used by others). Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation.
 

On Debian systems, the complete text of the GNU General Public License can be found in /usr/share/common-licenses/GPL.