de(4) DEC DC21x4x Ethernet device driver

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:
device de

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:


if_de_load="YES"

DESCRIPTION

The driver provides support for the Ethernet adapters based on the Digital Equipment DC21x4x based self-contained Ethernet and Fast Ethernet chips.

The driver supports the following media types:

autoselect
Enable autoselection of the media type and options
10baseT/UTP
Set 10Mbps operation on the 10baseT port
10base2/BNC
Set 10Mbps operation on the BNC port
10base5/AUI
Set 10Mbps operation on the AUI port
100baseTX
Set 100Mbps (Fast Ethernet) operation
100baseFX
Set 100Mbps operation
100baseT4
Set 100Mbps operation (4-pair cat-3 cable)

The driver supports the following media options:

full-duplex
Set full duplex operation

Note that the media types available depend on the particular card in use. Some cards are explicitly programmed to a particular media type by a setup utility and are not changeable.

Use the ifconfig(8) command and in particular the -m flag to list the supported media types for your particular card.

The old ``ifconfig linkN'' method of configuration is not supported.

HARDWARE

Adapters supported by the driver include:

  • Adaptec ANA-6944/TX
  • Cogent EM100FX and EM440TX
  • Corega FastEther PCI-TX
  • D-Link DFE-500TX
  • DEC DE435, DEC DE450, and DEC DE500
  • ELECOM LD-PCI2T, LD-PCITS
  • I-O DATA LA2/T-PCI
  • SMC Etherpower 8432, 9332 and 9334
  • ZNYX ZX3xx

DIAGNOSTICS

"de%d: waking device from sleep/snooze mode"
The 21041 and 21140A chips support suspending the operation of the card.
"de%d: error: desired IRQ of %d does not match device's actual IRQ of %d"
The device probe detected that the board is configured for a different interrupt than the one specified in the kernel configuration file.
"de%d: not configured; limit of %d reached or exceeded"
There is a limit of 32 devices allowed in a single machine.
"de%d: not configured; 21040 pass 2.0 required (%d.%d found)"
"de%d: not configured; 21140 pass 1.1 required (%d.%d found)"
Certain revisions of the chipset are not supported by this driver.

AUTHORS

An -nosplit The device driver was written by An Matt Thomas . This manual page was written by An David E. O'Brien .

SEE ALSO

LAST SEARCHED