For example,

        objdump -b oasys -m vax -h fu.o

displays summary information from the section headers (-h) of fu.o, which is explicitly identified (-m) as a VAX object file in the format produced by Oasys compilers. You can list the formats available with the -i option.

File segments may be relocated to nonstandard addresses, for example by using the -Ttext, -Tdata, or -Tbss options to ld. However, some object file formats, such as a.out, do not store the starting address of the file segments. In those situations, although ld relocates the sections correctly, using objdump -h to list the file section headers cannot show the correct addresses. Instead, it shows the usual addresses, which are implicit for the target.

If the target is an ARM architecture then this switch can be used to select which register name set is used during disassembler. Specifying -M reg-name-std (the default) will select the register names as used in ARM's instruction set documentation, but with register 13 called 'sp', register 14 called 'lr' and register 15 called 'pc'. Specifying -M reg-names-apcs will select the name set used by the ARM Procedure Call Standard, whilst specifying -M reg-names-raw will just use r followed by the register number.

There are also two variants on the APCS register naming scheme enabled by -M reg-names-atpcs and -M reg-names-special-atpcs which use the ARM/Thumb Procedure Call Standard naming conventions. (Either with the normal register names or the special register names).

This option can also be used for ARM architectures to force the disassembler to interpret all instructions as Thumb instructions by using the switch --disassembler-options=force-thumb. This can be useful when attempting to disassemble thumb code produced by other compilers.

For the x86, some of the options duplicate functions of the -m switch, but allow finer grained control. Multiple selections from the following may be specified as a comma separated string. x86-64, i386 and i8086 select disassembly for the given architecture. intel and att select between intel syntax mode and AT&T syntax mode. addr32, addr16, data32 and data16 specify the default address size and operand size. These four options will be overridden if x86-64, i386 or i8086 appear later in the option string. Lastly, suffix, when in AT&T mode, instructs the disassembler to print a mnemonic suffix even when the suffix could be inferred by the operands.

For PPC, booke, booke32 and booke64 select disassembly of BookE instructions. 32 and 64 select PowerPC and PowerPC64 disassembly, respectively.

For MIPS, this option controls the printing of instruction mneumonic names and register names in disassembled instructions. Multiple selections from the following may be specified as a comma separated string, and invalid options are ignored:

For any of the options listed above, ABI or ARCH may be specified as numeric to have numbers printed rather than names, for the selected types of registers. You can list the available values of ABI and ARCH using the --help option.