ubertooth-util(1) command line utility for Ubertooth Zero and Ubertooth One

SYNOPSIS

ubertooth-util [options]

OPTIONS

-a[0-7]
get/set power amplifier level
-b
get hardware board id number
-c[2400-2483]
get/set channel in MHz
-C[0-78]
get/set channel
-d[0-1]
get/set all LEDs
-e
start repeater mode
-f
activate flash programming (DFU) mode
-h
display help message
-i
activate In-System Programming (ISP) mode
-I
identify ubertooth device by flashing all LEDs
-l[0-1]
get/set USR LED
-m
display range test result
-n
initiate range test
-p
get microcontroller Part ID
-q[1-225 (RSSI threshold)]
start LED spectrum analyzer
-r
full reset
-s
get microcontroller serial number
-S
stop current operation
-t
intitiate continuous transmit test
-U<0-7>
set ubertooth device to use
-v
get firmware revision number
-V
get compile info
-z
set squelch level

AUTHOR

This manual page was written by Ruben Undheim <[email protected]> for the Debian project (and may be used by others).