SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device malo device pci device wlan device firmware

Alternatively, to load the driver as a module at boot time, place the following lines in loader.conf5:

if_malo_load="YES"

DESCRIPTION

The driver provides support for Marvell Libertas 88W8335 based PCI and Cardbus network adapters. supports station and monitor mode operation. Only one virtual interface may be configured at any time. For more information on configuring this device, see ifconfig(8).

This driver requires the malofw firmware kernel module be installed before it will work. The firmware files are not publicly available. A port of the firmware can be found at:

http://weongyo.org/project/malo/malo-firmware-1.4.tar.gz

The firmware kernel module can be installed by extracting the archive and running `make' install clean in the malo-firmware-1.4 directory.

HARDWARE

The following cards are among those supported by the driver:

Card Ta Chip Ta Bus Ta Standard

"Netgear WG311v3" Ta 88W8335 Ta PCI Ta b/g

"Tenda TWL542P" Ta 88W8335 Ta PCI Ta b/g

"U-Khan UW-2054i" Ta 88W8335 Ta PCI Ta b/g

EXAMPLES

Join an existing BSS network (i.e., connect to an access point):

ifconfig wlan create wlandev malo0 inet 192.168.0.20 \
    netmask 0xffffff00

Join a specific BSS network with network name ``my_net ''

"ifconfig wlan create wlandev malo0 ssid my_net up"

Join a specific BSS network with 64-bit WEP encryption:

ifconfig wlan create wlandev malo0 ssid my_net \
        wepmode on wepkey 0x1234567890 weptxkey 1 up

HISTORY

The device driver first appeared in Fx 7.1 .